89413N
1.INSTALL TRANSMISSION REVOLUTION SENSOR (NT)
Apply Toyota Genuine CVT fluid FE to a new O-ring.
Install the O-ring to the transmission revolution sensor (NT).
Install the transmission revolution sensor (NT) to the continuously variable transaxle assembly with the bolt.
Connect the connector.
89413M
2.INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)
Apply Toyota Genuine CVT fluid FE to a new O-ring.
Install the O-ring to the transmission revolution sensor (NOUT).
Install the transmission revolution sensor (NOUT) to the continuously variable transaxle assembly with the bolt.
Connect the connector.
89413P
3.INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)
Apply Toyota Genuine CVT fluid FE to a new O-ring.
Install the O-ring to the transmission revolution sensor (NIN).
Install the transmission revolution sensor (NIN) to the continuously variable transaxle assembly with the bolt.
Connect the connector.
74404A
4.INSTALL BATTERY CLAMP SUB-ASSEMBLY
89661
5.INSTALL ECM
6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17705
7.INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE
17751
8.INSTALL NO. 1 AIR CLEANER INLET
53141F
9.INSTALL RADIATOR COVER
28800
10.INSTALL BATTERY
11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
11212
12.INSTALL NO. 2 CYLINDER HEAD COVER
13.CHECK DATA LIST
14. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
When disconnecting and reconnecting the battery, there is an automatic leaning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART