Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › from 2015.04
RM19V0EQ _58 Vehicle Interior _034909 PRE-CRASH SAFETY _0163370 PRE-CRASH SAFETY SYSTEM T

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Symptom Suspected Area Link
"Check Pre-crash Safety" is displayed Combination meter assembly Click here
Driving support ECU assembly Click here
"Pre-crash Safety Temporarily Not Available" is displayed System determines the millimeter wave radar sensor assembly cannot detect obstacles due to dirt on the millimeter wave radar sensor assembly or radiator grille. If dirt is removed, normal control returns. (Millimeter wave radar sensor assembly dirt history can be checked using Data List) Click here
System determines millimeter wave radar sensor assembly cannot detect obstacles due to bad weather. If weather recovers, normal control returns. (Bad weather history can be checked using Data List.) Click here
Millimeter wave radar sensor assembly Click here
Combination meter assembly Click here
Driving support ECU assembly Click here
Although there is possibility of collision, pre-crash safety control (all front collision controls) does not operate ("Pre-crash Safety temporarily not available" is not displayed) Vehicle condition/environment does not match pre-crash control operation conditions (Confirm control operation conditions) Click here
Pre-crash system circuit Click here
Check installation condition of millimeter wave radar sensor assembly Click here
Perform millimeter wave radar sensor assembly adjustment Click here
Millimeter wave radar sensor assembly Click here
Driving support ECU assembly Click here
Although there is no possibility of collision, pre-crash safety controls (all front crash controls) operate Vehicle condition/environment does not match pre-crash control operation conditions (Confirm control operation conditions) Click here
Pre-crash system circuit Click here
Check installation condition of millimeter wave radar sensor assembly Click here
Perform millimeter wave radar sensor assembly adjustment Click here
Millimeter wave radar sensor assembly Click here
Driving support ECU assembly Click here
Pre-crash safety system cannot be canceled (PCS warning indicator does not illuminate) Combination meter assembly (Check if indicator illuminates using Active Test) Click here
Pre-crash system cancel switch circuit Click here
Driving support ECU assembly Click here
Pre-crash brake assist and pre-crash brake control cannot be canceled (PCS warning indicator does not illuminate) Combination meter assembly (Check if indicator illuminates using Active Test) Click here
VSC OFF switch circuit Click here
Driving support ECU assembly Click here
Pre-crash safety system sensitivity cannot be changed (multi-information display sensitivity setting screen does not display) Pre-crash system cancel switch circuit Click here
Pre-crash System Circuit Click here
Combination meter assembly Click here
Driving support ECU assembly Click here