46420B
1.INSTALL NO. 2 PARKING BRAKE CABLE CLAMP
Install the No. 2 parking brake cable clamp to the No. 3 parking brake cable assembly.
46430
2.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY
Install the No. 3 parking brake cable assembly with the 4 bolts and nut.
Install the clip to the No. 3 parking brake cable assembly.
46430
3.CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY
Turn and connect the No. 3 parking brake cable assembly.
Using a brass bar and a hammer, install the clip to the No. 3 parking brake cable assembly.
17410
4.INSTALL FRONT EXHAUST PIPE ASSEMBLY
46440
5.INSTALL NO. 4 PARKING BRAKE CABLE ASSEMBLY
| *1 | No. 4 Parking Brake Cable Assembly |
| *2 | Rubber Boot |
| *3 | Parking Brake Equalizer |
Install the No. 4 parking brake cable assembly to the parking brake equalizer.
Slide the parking brake equalizer and rubber boot as shown in the illustration.
Make sure that the rubber boot is securely inserted into the groove of the No. 4 parking brake cable assembly.
| *1 | Parking Brake Equalizer |
| *2 | No. 2 Parking Brake Cable Assembly |
| *3 | No. 3 Parking Brake Cable Assembly |
| *4 | No. 4 Parking Brake Cable Assembly |
Connect the No. 3 parking brake cable assembly to the parking brake equalizer.
Connect the No. 2 parking brake cable assembly to the parking brake equalizer.
57054B
6.INSTALL NO. 4 CROSS MEMBER FLOOR REINFORCEMENT SUB-ASSEMBLY (for RHD)
Install the No. 4 cross member floor reinforcement sub-assembly with the 6 bolts.
Install the floor carpet.
Engage the guide to connect the fuel lid lock open lever sub-assembly as shown in the illustration.
Install the screw.
58569D
7.INSTALL FRONT FLOOR CAUTION PLATE COVER (for RHD)
Use the same procedure as for LHD.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING UNIT>INSTALLATION
58521B
8.INSTALL FLOOR CARPET HOOK (for RHD)
9.INSTALL STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET (for RHD)
for 10 Speakers: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>INSTALLATION
86183D
10.INSTALL AUDIO AMPLIFIER COVER (for RHD)
for 10 Speakers: Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>INSTALLATION
11.INSTALL FRONT SEAT ASSEMBLY LH (for RHD)
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION
12.INSTALL FRONT SEAT ASSEMBLY RH (for RHD)
Use the same procedure as for the LH side.
62414A
13.INSTALL CENTER PILLAR LOWER GARNISH LH (for RHD)
73220
14.CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (for RHD)
73233
15.INSTALL LAP BELT OUTER ANCHOR COVER (for RHD)
Remove the lap belt outer anchor cover (for LH Side).
Click hereVehicle Interior>SEAT BELT>FRONT SEAT OUTER BELT ASSEMBLY>INSTALLATION
62332A
16.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP LH (for RHD)
67918A
17.INSTALL REAR DOOR SCUFF PLATE LH (for RHD)
62413A
18.INSTALL CENTER PILLAR LOWER GARNISH RH (for RHD)
19.CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH (for RHD)
73233
20.INSTALL LAP BELT OUTER ANCHOR COVER (for RHD)
Remove the lap belt outer anchor cover (for RH Side).
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION
62331A
21.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH (for RHD)
67917A
22.INSTALL REAR DOOR SCUFF PLATE RH (for RHD)
46410
23.INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY (for LHD)
Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
Install the clip to the No. 1 parking brake cable assembly.
Temporarily install the adjusting nut.
Bend the parking brake pedal claw.
46410
24.INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY (for RHD)
Pass the No. 1 parking brake cable assembly through the parking brake pedal assembly.
Install the clip to the No. 1 parking brake cable assembly.
Temporarily install the adjusting nut.
Bend the parking brake pedal claw.
46201
25.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY (for LHD)
46201
26.INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY (for RHD)