Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE CARRIER
RM2040EQ _52 Drivetrain _014703 AXLE AND DIFFERENTIAL _0074962 REAR AXLE CARRIER A

AXLE AND DIFFERENTIAL  REAR AXLE CARRIER  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:

When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 55702A 3.REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 4.DISABLE BRAKE CONTROL

Hide 5.REMOVE REAR WHEEL

Hide 6.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42491 7.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 42431 8.REMOVE REAR DISC

Hide 89516D 9.DISCONNECT SKID CONTROL SENSOR WIRE

Hide 42450B 10.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

Hide 48780A 11.SEPARATE REAR STRUT ROD ASSEMBLY

a.
C240579C08
1.573,1.948 1.917,1.948 false 1.781,1.656 2.021,1.656 false 2.552,4.146 3,4.146 false 1.958,1.865 2.198,2.073 0.24,0.208 10 false *1 2.063,1.573 2.292,1.813 0.229,0.24 10 false *2 3.031,4.063 3.26,4.271 0.229,0.208 10 false *2
*1 Jack
*2 Wooden Block


Use a jack and wooden block to support the rear axle carrier sub-assembly.


b.

Remove the bolt and nut, and separate the rear strut rod assembly (rear side) from the rear axle carrier sub-assembly.

NOTICE:

When removing the bolt, keep the nut from rotating.



Hide 48740F 12.SEPARATE REAR NO. 2 SUSPENSION ARM ASSEMBLY

a.
C144132

Remove the bolt and nut, and separate the rear No. 2 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.

NOTICE:

When removing the bolt, keep the nut from rotating.



Hide 48720A 13.SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY

a.
C144131

Remove the bolt and nut, and separate the rear No. 1 suspension arm assembly (outer side) from the rear axle carrier sub-assembly.

NOTICE:

When removing the bolt, keep the nut from rotating.



Hide 42305 14.REMOVE REAR AXLE CARRIER SUB-ASSEMBLY

a.
C241258

Remove the 2 bolts, 2 nuts and rear axle carrier sub-assembly from the rear shock absorber assembly.

NOTICE:

When removing the nuts, keep the bolts from rotating.