DTC P0340 Camshaft Position Sensor Circuit Malfunction |
DTC P0342 Camshaft Position Sensor "A" Circuit Low Input (Bank 1 or Single Sensor) |
DTC P0343 Camshaft Position Sensor "A" Circuit High Input (Bank 1 or Single Sensor) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0340 | Either of the following conditions is met (1 trip detection logic):
|
|
| P0342 | The output voltage of the camshaft position sensor (for intake camshaft) is less than 0.3 V for 4 seconds (1 trip detection logic). |
|
| P0343 | The output voltage is higher than 4.7 V for 4 seconds (1 trip detection logic). |
|
![]() |
| ECM Terminal Name | Between VV1+ and VV1- |
| Tester Range | 5 V/DIV., 20 ms./DIV. |
| Condition | Idling |
| Required Sensors/Components (Main) | Camshaft position sensor (for intake camshaft) |
| Required Sensors/Components (Related) | Crankshaft position sensor |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.CHECK TERMINAL VOLTAGE (POWER SOURCE OF CAMSHAFT POSITION SENSOR (FOR INTAKE CAMSHAFT)) |
![]() |
Disconnect the camshaft position sensor (for intake camshaft) connector.
Turn the power switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E55-3 (VC) - Body ground | Power switch on (IG) | 4.5 to 5.5 V |
| *a | Front view of wire harness connector (to Camshaft Position Sensor (for Intake Camshaft)) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR (FOR INTAKE CAMSHAFT) - ECM) |
Disconnect the camshaft position sensor (for intake camshaft) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E55-1 (VVI+) - E28-82 (VV1+) | Always | Below 1 Ω |
| E55-2 (VVI-) - E28-114 (VV1-) | Always | Below 1 Ω |
| E55-1 (VVI+) or E28-82 (VV1+) - Body ground | Always | 10 kΩ or higher |
| E55-2 (VVI-) or E28-114 (VV1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.CHECK SENSOR INSTALLATION (CAMSHAFT POSITION SENSOR (FOR INTAKE CAMSHAFT)) |
![]() |
Check the camshaft position sensor (for intake camshaft) installation.
|
| ||||
| OK | |
| 4.INSPECT INTAKE CAMSHAFT (TIMING ROTOR) |
Check the timing rotor of the intake camshaft.
|
| ||||
| OK | |
| 5.CHECK VALVE TIMING (CHECK FOR LOOSE TIMING CHAIN AND JUMPED TEETH) |

| *a | Timing Mark | - | - |
Remove the cylinder head cover sub-assembly (Click here).
Turn the crankshaft pulley and align its groove with the "0" timing mark of the timing chain cover.
Check that the timing marks of the camshaft timing gear assembly and camshaft timing sprocket are at the positions shown in the illustration.
|
| ||||
| OK | |
| 6.REPLACE CAMSHAFT POSITION SENSOR (FOR INTAKE CAMSHAFT) |
Replace the camshaft position sensor (for intake camshaft) (Click here).
| NEXT | |
| 7.CHECK WHETHER DTC OUTPUT RECURS (DTC P0340, P0342 OR P0343) |
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Clear the DTCs (Click here).
Turn the power switch off and wait for at least 30 seconds.
Turn the power switch on (IG).
Turn the GTS on.
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0340, P0342 or P0343 is output | A |
| DTCs are not output | B |
|
| ||||
| A | ||
| ||
| 8.CHECK HARNESS AND CONNECTOR (CAMSHAFT POSITION SENSOR (FOR INTAKE CAMSHAFT) - ECM) |
Disconnect the camshaft position sensor (for intake camshaft) connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E55-3 (VC) - E28-113 (VCV1) | Always | Below 1 Ω |
| E55-3 (VC) or E28-113 (VCV1) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||