Home › Engine / Hybrid System ยท 2GR-FE › ENGINE CONTROL › SFI SYSTEM

SFI SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


SFI System 
Symptom
Suspected Area
See page
Engine does not crank (Does not start)
Battery
Click here
VC output circuit (ECM 5 V output)
Click here
Starter signal circuit
Click here
Smart entry and start system
Click here
Starter assembly
Click here
No initial combustion (Does not start)
Immobiliser system
Click here
ECM power source circuit
Click here
VC output circuit (ECM 5 V output)
Click here
Crankshaft position sensor
Click here
VVT sensor (for intake camshaft)
Click here
VVT sensor (for exhaust camshaft)
Click here
Ignition system
Click here
Fuel injector circuit
Click here
Valve timing
Click here
Starter signal circuit
Click here
Fuel pump control circuit
Click here
ECM
Click here
No. 1 valve rocker arm sub-assembly*
Click here
Engine cranks normally but difficult to start
Flow chart [Engine difficult to start]
Click here
Engine coolant temperature sensor
Click here
Ignition system
Click here
Fuel injector assembly
Click here
Compression
Click here
Fuel injector circuit
Click here
Intake system
Click here
Throttle with motor body assembly
Click here
ECM power source circuit
Click here
Starter signal circuit
Click here
Fuel pump control circuit
Click here
No. 1 valve rocker arm sub-assembly*
Click here
Incomplete intermittent combustion occurs (Does not start)
Fuel line
-
Ignition system
Click here
Fuel injector assembly
Click here
Crankshaft position sensor
Click here
Valve timing
Click here
Fuel pump control circuit
Click here
High engine speed
Air conditioning signal circuit
Click here
Throttle with motor body assembly
Click here
Engine coolant temperature sensor
Click here
PCV valve and hose
Click here
ECM power source circuit
Click here
Low engine speed (Poor idle)
Throttle with motor body assembly
Click here
Intake system
Click here
PCV valve and hose
Click here
Fuel pump control circuit
Click here
Engine stalls on deceleration
Flow chart [Engine stalls]
Click here
Idle speed (refer to "Low engine speed")
Click here
Rough idle
Flow chart [Rough idling]
Click here
Compression (engine mechanical)
Click here
Air fuel ratio sensor
Click here
Heated oxygen sensor
Click here
Mass air flow meter sub-assembly
Click here
Ignition system
Click here
Air conditioning signal circuit
Click here
Fuel line
-
Valve timing
Click here
Intake system
Click here
PCV valve and hose
Click here
Fuel pump control circuit
Click here
External part malfunction (Increase in load: A/C system, A/T system, etc.)
-
No. 1 valve rocker arm sub-assembly*
Click here
Hunting (Poor idle)
PCV valve and hose
Click here
Mass air flow meter sub-assembly
Click here
Air fuel ratio sensor
Click here
Lack of power
Flow chart [Lack of power]
Click here
Engine stalls during air conditioning operation
Air conditioning signal circuit
Click here
ECM
Click here
Hesitation/Poor acceleration (Poor driveability)
Fuel line
-
Valve timing
Click here
Mass air flow meter sub-assembly
Click here
Throttle with motor body assembly
Click here
Knock control sensor
Click here
Fuel pump control circuit
Click here
Brake override system
Click here
No. 1 valve rocker arm sub-assembly*
Click here
Surging (Poor driveability)
Fuel line
-
Ignition system
Click here
Fuel injector assembly
Click here
Fuel pump control circuit
Click here
No. 1 valve rocker arm sub-assembly*
Click here
Engine stalls soon after starting
Flow chart [Engine stalls]
Click here
Mass air flow meter sub-assembly
Click here
Intake system
Click here
Fuel line
-
No. 1 valve rocker arm sub-assembly*
Click here
Engine vibrates frequently when idling (Active control engine mount system)
Active control engine mount circuit
Click here

HINT:
*: Check the "Fuel Cut Elps Time" in the Data List.
If the elapsed time is over 0 sec, then the engine speed is high (More than the engine speed at which fuel cut occurs + 500 rpm).
When this has happened, there is the possibility that the No. 1 valve rocker arm sub-assembly will become loose and malfunction, so check that the No. 1 valve rocker arm sub-assembly is properly attached (Click here).