P28077F
| 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
DTC Detection Condition 1: - ATF temperature is -10°C (14°F) or more, and the vehicle is being driven with the shift lever in D (no malfunctions are detected in the shift solenoid valves (SL1, SL2, SL3 and SL4), transmission revolution sensor (NT, NC), coolant temperature sensor, oil temperature sensor, knock control sensor, electronic throttle, or CAN2)
- Both of the following conditions (a) and (b) are met:
- When the ECM commands the transaxle to shift to 3rd gear, the actual gear is shifted to 1st.
- When the ECM commands the transaxle to shift to 5th gear, the engine overruns.
- 0.5 seconds
- 2-trip detection logic
DTC Detection Condition 2: - ATF temperature is -10°C (14°F) or more, and the vehicle is being driven with the shift lever in D (no malfunctions are detected in the shift solenoid valves (SL1, SL2, SL3 and SL4), transmission revolution sensor (NT, NC), coolant temperature sensor, oil temperature sensor, knock control sensor, electronic throttle, or CAN2)
- Both of the following conditions (a) and (b) are met:
- When the ECM commands the transaxle to shift to 1st or 2nd gear, the actual gear is shifted to 3rd.
- When the ECM commands the transaxle to shift to 6th gear, the actual gear is shifted to 5th.
- 0.8 seconds
- 2-trip detection logic
| - Shift solenoid valve SL4 remains open or closed
- Transmission valve body assembly is blocked
- Automatic transaxle assembly (clutch, brake, gear, etc.)
|