DTC P07407F Torque Converter Clutch Actuator Stuck Off |
| DTC No. | DTC Detection Condition | Trouble Area |
| P07407F | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|
| ACTIVE TEST |
Warm up the engine.
Turn the engine switch off.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Active Test / Activate the Lock Up Solenoid.
Perform the Active Test according to the display on the GTS.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Activate the Lock Up Solenoid | Controls the shift solenoid valves SLU and SL to control the automatic transaxle lock-up condition | ON/OFF | Can be used to check the operation of the shift solenoid valves SLU and SL. [Vehicle Condition]
|
Lightly depress the accelerator pedal and check that the engine speed does not change abruptly.

| 1.CHECK OTHER DTCS OUTPUT (IN ADDITION TO DTC P07407F) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Read the DTCs using the GTS.
| Result | Proceed to |
| Only DTC P07407F is output | A |
| DTC P07407F and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK TRANSMISSION WIRE |
![]() |
Remove the wiring harness connector.
| *a | Component without harness connected (Transmission Wire) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A-6 (SL) - Body ground | 20°C (68°F) | 11 to 15 Ω |
|
| ||||
| OK | |
| 3.INSPECT SHIFT SOLENOID VALVE SL (OPERATION) |
![]() |
Remove shift solenoid valve SL.
| *1 | Shift Solenoid Valve SL |
Connect a positive (+) lead from the battery to the terminal of the solenoid valve connector and a negative (-) lead to the solenoid body. Check that the valve moves and makes an operating sound.
|
| ||||
| OK | |
| 4.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly (Click here).
|
| ||||
| OK | |
| 5.INSPECT TORQUE CONVERTER ASSEMBLY |
Check the torque converter assembly (Click here).
|
| ||||
| OK | ||
| ||
| 6.INSPECT SHIFT SOLENOID VALVE SL (RESISTANCE) |
![]() |
Remove the shift solenoid valve SL.
| *1 | Shift Solenoid Valve SL |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Solenoid Connector (SL) - Solenoid Body (SL) | 20°C (68°F) | 11 to 15 Ω |
|
| ||||
| OK | ||
| ||