Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for 2AR-FE) › 2017.12–2018.08
RM33A0E _51 Engine / Hybrid System _065357 CRUISE CONTROL _0327281 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE) T

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for 2AR-FE)  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

Before replacing the ECM, refer to Service Bulletin.

·

When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.

·

When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT

·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)



HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Dynamic Radar Cruise Control System
Symptom Suspected Area Link
The dynamic radar cruise control system cannot be turned on using the cruise control main switch CAN communication system Click here
Steering Pad switch circuit Click here
Cruise main indicator light circuit Click here
ECU Power Source Circuit Click here
Combination meter assembly Click here
Millimeter wave radar sensor assembly Click here
ECM Click here
The dynamic radar cruise control mode cannot be changed between vehicle-to-vehicle distance control mode and constant speed control mode CAN communication system Click here
Steering Pad switch circuit Click here
Combination meter assembly Click here
ECM Click here
The vehicle-to-vehicle distance cannot be changed CAN communication system Click here
Distance control switch circuit Click here
Combination meter assembly Click here
Forward recognition camera Click here
ECM Click here
Vehicle speed setting cannot be performed (in constant speed control mode) Fail-safe chart Click here
CAN communication system Click here
Steering Pad switch circuit Click here
Stop light switch circuit Click here
Automatic transaxle system Click here
Vehicle stability control system Click here
Millimeter wave radar sensor assembly Click here
ECM Click here
Vehicle speed setting cannot be performed (in vehicle-to-vehicle distance control mode) Perform millimeter wave radar sensor assembly adjustment*1 Click here
Fail-safe chart Click here
Forward recognition camera is temporarily unavailable Click here
Millimeter wave radar sensor is dirty Click here
Millimeter wave radar sensor assembly beam axis not adjusted Click here
CAN communication system Click here
Steering Pad switch circuit Click here
Automatic transaxle system Click here
Millimeter wave radar sensor assembly Click here
Forward recognition camera Click here
Vehicle stability control system Click here
Combination meter assembly Click here
ECM Click here
Control of vehicle speed by the dynamic radar cruise control system is canceled (in constant speed control mode) Fail-safe chart Click here
CAN communication system Click here
Steering Pad switch circuit Click here
Stop light switch circuit Click here
Automatic transaxle system Click here
Vehicle stability control system Click here
Millimeter wave radar sensor assembly Click here
ECM Click here
Control of vehicle speed by the dynamic radar cruise control system is canceled (in vehicle-to-vehicle distance control mode) Perform millimeter wave radar sensor assembly adjustment*1 Click here
Fail-safe chart Click here
Forward recognition camera is temporarily unavailable Click here
Millimeter wave radar sensor is dirty Click here
Millimeter wave radar sensor assembly beam axis not adjusted Click here
CAN communication system Click here
Steering Pad switch circuit Click here
Automatic transaxle system Click here
Millimeter wave radar sensor assembly Click here
Forward recognition camera Click here
Vehicle stability control system Click here
Combination meter assembly Click here
ECM Click here
Hunting/vehicle speed is not constant (in constant speed control mode) CAN communication system Click here
Vehicle stability control system Click here
ECM Click here
Hunting/vehicle speed is not constant (in vehicle-to-vehicle distance control mode) Millimeter wave radar sensor assembly is dirty Click here
Millimeter wave radar sensor assembly beam axis not adjusted Click here
CAN communication system Click here
Vehicle stability control system Click here
Millimeter wave radar sensor assembly Click here
ECM Click here
Vehicle speed control by the cruise control system is not canceled when the CANCEL switch is pushed Steering Pad switch circuit Click here
ECM Click here
Moving the shift lever does not cancel control of vehicle speed by the dynamic radar cruise control system Park/neutral position switch assembly Click here
Shift lock control unit assembly Click here
Automatic transaxle system Click here
ECM Click here
Vehicle speed control by the cruise control system is not canceled when a shift paddle switch is operated*2 Automatic transaxle system Click here
Shift paddle switch circuit Click here
ECM Click here
Depressing the brake pedal does not cancel control of vehicle speed by the dynamic radar cruise control system Stop light switch circuit Click here
ECM Click here
Control cannot be canceled while the vehicle is stopped CAN communication system Click here
Vehicle stability control system Click here
Front door courtesy switch circuit Click here
Luggage compartment door courtesy switch circuit Click here
Seat belt warning system Click here
Theft deterrent system Click here
ECM Click here
Control cannot be canceled by operating the parking brake CAN communication system Click here
Vehicle stability control system Click here
Electric parking brake system Click here
Brake actuator assembly (for LHD) Click here
Brake actuator assembly (for RHD) Click here
Millimeter wave radar sensor assembly Click here
ECM Click here
Even though the millimeter wave radar sensor assembly is not dirty, the warning message "Clean Sensor" is displayed Millimeter wave radar sensor assembly Click here
The vehicle approach warning buzzer does not sound Combination meter assembly Click here
Check millimeter wave radar sensor assembly installation position Click here
Check installation of forward recognition camera Click here
Forward recognition camera Click here
Millimeter wave radar sensor assembly Click here
Even though the vehicle approach warning buzzer is sounding, brake control is not performed to decelerate the vehicle Vehicle stability control system Click here
CAN communication system Click here
Millimeter wave radar sensor assembly Click here
ECM Click here
Even though the SET function is operating, the cruise SET indicator does not illuminate CAN communication system Click here
Cruise SET indicator light circuit Click here
Combination meter assembly Click here
ECM Click here
The cruise control indicator remains illuminated CAN communication system Click here
Cruise main indicator light circuit Click here
Combination meter assembly Click here
ECM Click here
Indicators are not displayed on the multi-information display in the combination meter assembly CAN communication system Click here
Combination meter assembly Click here
ECM Click here
A buzzer does not sound when control of vehicle speed by the dynamic radar cruise control is canceled CAN communication system Click here
Combination meter assembly Click here
ECM Click here

*1: If error code 7 is output during beam axis alignment, clear the DTCs and perform beam axis alignment again.

*2: w/ Shift Paddle Switch