Home › Engine / Hybrid System › 6AR-FSE (EMISSION CONTROL) › EGR COOLER › 2018.04–2021.02
RM33A0E _51 Engine / Hybrid System _072205 6AR-FSE EMISSION CONTROL _0353747 EGR COOLER A

6AR-FSE EMISSION CONTROL  EGR COOLER  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control) (Click here)
Pre-collision system
Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)
·

Replacement of EGR valve assembly

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 1.DRAIN ENGINE COOLANT

Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17705 3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

Hide 4.REMOVE BATTERY

Hide 9.REMOVE EGR VALVE WITH COOLER ASSEMBLY

Hide 25680 10.REMOVE EGR COOLER ASSEMBLY

a.
A338760

Slide the clip and disconnect the No. 1 water by-pass hose from the EGR cooler assembly.


b.
A338763

Remove the 2 nuts and EGR cooler assembly from the EGR valve assembly.


c.
A338988

Remove the EGR valve gasket from the EGR valve assembly.