The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator assembly removal/installation are shown below.
53851M
1.REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
53852K
2.REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
5.REMOVE HEADLIGHT ASSEMBLY
for LED Type Turn Signal Light: Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for LED Type Turn Signal Light)>REMOVAL
for Bulb Type Turn Signal Light: Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY (for Bulb Type Turn Signal Light)>REMOVAL
88790B
6.REMOVE THERMISTOR ASSEMBLY
52611
7.REMOVE FRONT BUMPER ENERGY ABSORBER
52131A
8.REMOVE FRONT BUMPER REINFORCEMENT
53510
9.REMOVE HOOD LOCK ASSEMBLY
17750A
10.REMOVE INLET AIR CLEANER ASSEMBLY
53253B
11.REMOVE UPPER RADIATOR MOUNTING BRACKET
Disconnect the 2 horn connectors.
Remove the 2 bolts, 2 nuts and 2 upper radiator mounting brackets.
16595B
12.REMOVE NO. 1 RADIATOR AIR GUIDE LH
| *1 | No. 1 Radiator Air Guide LH |
| *2 | Front Radiator Side Air Guide Plate LH |
Remove the clip and disengage the claw.
Disengage the guide to remove the No. 1 radiator air guide LH with the front radiator side air guide plate LH.
16593B
13.REMOVE NO. 1 RADIATOR AIR GUIDE RH
Remove the clip and disengage the claw.
Disengage the guide to remove the No. 1 radiator air guide RH.
53205
14.REMOVE UPPER RADIATOR SUPPORT SUB-ASSEMBLY
Disengage the clamp to disconnect the hood lock control cable assembly from the upper radiator support sub-assembly.
Remove the 4 bolts and upper radiator support sub-assembly.
16281F
15.DISCONNECT NO. 5 WATER BY-PASS HOSE
| *1 | Hose Clamp (A) |
| *2 | Hose Clamp (B) |
Disengage the 4 clamps to disconnect the No. 5 water by-pass hose and No. 6 water by-pass hose from the hose clamp (A).
Disengage the 2 clamps to remove the hose clamp (B) from the No. 5 water by-pass hose and No. 6 water by-pass hose.
Slide the clip and disconnect the No. 5 water by-pass hose from the radiator assembly.
16571C
16.DISCONNECT NO. 1 RADIATOR HOSE
Disengage the clamp and disconnect the No. 1 radiator hose from the fan with motor assembly.
Slide the clip and disconnect the No. 1 radiator hose from the radiator assembly.
16572D
17.DISCONNECT NO. 2 RADIATOR HOSE
Slide the clip and disconnect the No. 2 radiator hose from the radiator assembly.
16400
18.REMOVE RADIATOR ASSEMBLY
Disengage the 2 claws.
Disengage the 2 guides to separate the cooler condenser assembly from the radiator assembly.
Make sure not to damage the cooler condenser assembly when separating the cooler condenser assembly.
Disconnect the cooling fan motor connector. (for 330 W Cooling Fan Motor)
| *a | Lock Lever |
Disengage the claw and raise the lock lever to disconnect the cooling fan motor connector as shown in the illustration.
After disconnecting the cooling fan motor connector, make sure that dirt, water or other foreign matter does not contact the connecting parts of the cooling fan motor connector.
Disengage the wire harness clamp.
Disconnect the cooling fan motor connector. (for 500 W Cooling Fan Motor)
Disconnect the cooling fan motor connector.
Disengage the wire harness clamp.
Rotate the lever while pushing the lock, and disconnect the cooling fan motor connector.
After disconnecting the cooling fan motor connector, make sure that dirt, water or other foreign matter does not contact the connecting parts of the cooling fan motor connector.
Disengage the wire harness clamp.
Remove the radiator assembly with the fan with motor assembly from the vehicle body.
Do not apply excessive force to the cooler condenser assembly or pipe when removing the radiator assembly with the fan with motor assembly.
Disengage the 2 claws.
Disengage the 2 guides to remove the fan with motor assembly from the radiator assembly.
Do not damage the radiator assembly when removing the fan with motor assembly.
16523A
19.REMOVE RADIATOR SUPPORT CUSHION
Remove the 2 radiator support cushions from the radiator assembly.
16535
20.REMOVE LOWER RADIATOR SUPPORT
Remove the 2 lower radiator supports from the radiator assembly.