16400
1.REMOVE RADIATOR ASSEMBLY
17201
2.REMOVE TURBOCHARGER SUB-ASSEMBLY
23670
3.REMOVE INJECTOR ASSEMBLY
22100
4.REMOVE INJECTION OR SUPPLY PUMP ASSEMBLY
16577C
5.REMOVE RADIATOR PIPE
87208L
6.REMOVE WATER PIPE SUB-ASSEMBLY
16206B
7.REMOVE NO. 3 WATER BY-PASS PIPE SUB-ASSEMBLY
16206
8.REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY
88320
9.SEPARATE COOLER COMPRESSOR ASSEMBLY (w/ Air Conditioning System)
88431
10.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)
16630G
11.REMOVE IDLER PULLEY ASSEMBLY
88420
12.REMOVE IDLE PULLEY ASSEMBLY WITH BRACKET (w/ Air Conditioning System)
16100
13.REMOVE ENGINE WATER PUMP ASSEMBLY
27020
14.REMOVE GENERATOR ASSEMBLY
15.REMOVE CAMSHAFT POSITION SENSOR
19971E
16.REMOVE VACUUM PIPE
29601B
17.REMOVE VACUUM PUMP OIL PIPE SUB-ASSEMBLY
29300
18.REMOVE VACUUM PUMP ASSEMBLY
13901
19.REMOVE NO. 1 VALVE ROCKER SHAFT SUB-ASSEMBLY
13781
20.REMOVE VALVE PUSH ROD
13819
21.REMOVE VALVE BRIDGE
11101
22.REMOVE CYLINDER HEAD SUB-ASSEMBLY
11115
23.REMOVE CYLINDER HEAD GASKET
Remove the cylinder head gasket.
13751
24.REMOVE VALVE LIFTER
13470
25.REMOVE CRANKSHAFT PULLEY ASSEMBLY
Using a 46 mm socket wrench, remove the nut, crankshaft pulley spacer and crankshaft pulley.
Insert a screwdriver through the inspection hole of the flywheel housing into the ring gear of the flywheel to keep it from turning together with the crankshaft.
11351H
26.REMOVE FLYWHEEL HOUSING STAY RH
Remove the 4 bolts and the flywheel housing stay RH.
11351G
27.REMOVE FLYWHEEL HOUSING STAY LH
Remove the 4 bolts and the flywheel housing stay LH.
12101
28.REMOVE OIL PAN SUB-ASSEMBLY
Remove the 26 bolts from the oil pan sub-assembly.
Insert the blade of oil pan seal cutter between the cylinder block and oil pan sub-assembly. Cut through the applied sealer and remove the oil pan sub-assembly.
Do not damage the contact surface of the cylinder block and oil pan sub-assembly.
12270
29.REMOVE OIL SEPARATOR ASSEMBLY
Remove the 5 bolts and the oil separator assembly.
Remove the 3 O-rings.
30.REMOVE TIMING GEAR CASE
Remove the 15 bolts.
Using a screwdriver with its tip wrapped in protective tape, pry out the timing gear case.
Do not damage the contact surfaces of the timing gear case, cylinder block and cylinder head sub-assembly.
11301C
31.REMOVE TIMING CHAIN OR BELT COVER OIL SEAL
Using a screwdriver with its tip wrapped in protective tape, pry out the timing chain or belt cover oil seal.
| *1 | Protective Tape |
| *2 | Piece of Cloth |
| *3 | Wooden Block |
Use wooden blocks and a piece of cloth to prevent the contact surfaces and the timing gear case from being damaged.
13501
32.REMOVE CAMSHAFT
Remove the 2 bolts and the camshaft.