Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for RHD vehicles.
1.DISCONNECT BATTERY NEGATIVE TERMINAL
2.REMOVE FRONT SEAT
63086A
3.REMOVE ROOF VENTILATOR LOUVER SUB-ASSEMBLY LH
63085A
4.REMOVE ROOF VENTILATOR LOUVER SUB-ASSEMBLY RH
53182A
5.REMOVE HEADLIGHT COVER LH
53181A
6.REMOVE HEADLIGHT COVER RH
Use the same procedure described for the LH side.
87945
7.REMOVE OUTER MIRROR COVER LH
87940
8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH
9.REMOVE FRONT PILLAR END COVER LH
10.REMOVE FRONT PILLAR END COVER RH
85292B
11.REMOVE FRONT WIPER ARM HEAD CAP
12.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
13.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
46243
14.REMOVE PARKING BRAKE LEVER COVER
58651A
15.REMOVE FRONT NO. 1 DOOR MAT PLATE
62311C
16.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
73233
17.REMOVE LAP BELT OUTER ANCHOR COVER
73210
18.REMOVE FRONT SEAT OUTER BELT ASSEMBLY RH
62413A
19.REMOVE LOWER CENTER PILLAR GARNISH RH
63951
20.REMOVE COOLER PIPE COVER
74617V
21.REMOVE ASSIST GRIP PLUG
74603
22.REMOVE FRONT ASSIST GRIP SUB-ASSEMBLY
62211
23.REMOVE FRONT PILLAR GARNISH RH
62212
24.REMOVE FRONT PILLAR GARNISH LH
73220
25.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH (w/ Rear No. 1 Seat)
62547B
26.REMOVE NO. 3 PILLAR GARNISH LH
65938
27.REMOVE NO. 3 CURTAIN RAIL (w/ Curtain)
63375B
28.REMOVE NO. 1 ROOF HEADLINING MOULDING RH (w/o Rear Air Duct)
63375D
29.REMOVE ROOF HEADLINING MOULDING (w/o Rear Air Duct)
63371B
30.REMOVE NO. 1 ROOF BOARD SET MOULDING
63610
31.REMOVE NO. 1 AIR OUTLET REGISTER ASSEMBLY (w/ Rear Air Duct)
74310
32.REMOVE VISOR ASSEMBLY RH
74320
33.REMOVE VISOR ASSEMBLY LH (w/ Passenger Side Visor)
63310A
34.REMOVE ROOF HEADLINING ASSEMBLY HOLE PLUG (w/ Cover)
83910G
35.REMOVE CLOCK ASSEMBLY
87810
36.REMOVE INNER REAR VIEW MIRROR ASSEMBLY
63656D
37.REMOVE CENTER AIR INTAKE COVER (w/ Rear Air Duct)
63651B
38.REMOVE AIR INTAKE NET (w/ Rear Air Duct)
55905H
39.REMOVE CONTROL KNOB SUB-ASSEMBLY (w/o Rear Air Duct)
63812
40.REMOVE NO. 2 ROOF VENTILATOR COVER (w/o Rear Air Duct)
63310
41.REMOVE ROOF HEADLINING ASSEMBLY
56111
42.REMOVE WINDSHIELD GLASS
The windshield glass may fall while performing this procedure. Therefore, use suction cups to hold the windshield glass from the outside of the vehicle.
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
| *1 | Protective Tape |
Place matchmarks over the glass and vehicle body at the locations indicated in the illustration.
Matchmarks do not need to be placed if not reusing the glass.
| *a | Matchmarks |
Install the suction cups to the windshield glass.
From the interior, insert a piano wire between the vehicle body and glass.
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
When separating the glass from the vehicle, do not damage the vehicle paint or interior/exterior ornaments.
To prevent the instrument panel from being scratched when removing the glass, place a plastic sheet between the piano wire and instrument panel.
| *1 | Piano Wire |
| *2 | Windshield Glass Stopper |
| *3 | No. 2 Windshield Glass Stopper |
Cut through the adhesive by pulling the piano wire around the glass.
Using suction cups, disconnect the 2 stoppers and remove the windshield glass.
Be careful not to drop the windshield glass.
75535E
43.REMOVE OUTSIDE LOWER WINDSHIELD MOULDING
When reusing the windshield glass:
Using a scraper, remove the outside lower windshield moulding.
Do not damage the windshield glass.
Be sure to replace the outside lower windshield moulding with a new one.
| *a | Back Side |
56115F
44.REMOVE WINDSHIELD GLASS STOPPER
When reusing the windshield glass:
Using a scraper, remove the No. 2 windshield glass stopper.
Do not damage the windshield glass.
Be sure to replace the No. 2 windshield glass stopper with a new one.
| *a | Back Side |
56116E
45.REMOVE NO. 2 WINDSHIELD GLASS STOPPER
When reusing the windshield glass:
Using a scraper, remove the windshield glass stopper.
| *a | Back Side |
Do not damage the windshield glass.
Be sure to replace the No. 2 windshield glass stopper with a new one (Type B).
| *A | TypeA |
| *B | TypeB |
| *a | Back Side |
56114C
46.REMOVE WINDSHIELD GLASS RETAINER
When reusing the windshield glass:
Using a scraper, remove the 5 windshield glass retainers.
Do not damage the windshield glass.
Be sure to replace the windshield glass retainer with a new one.
64818A
47.REMOVE BACK WINDOW GLASS SPACER
Using a scraper, remove the 5 back window glass spacers.
Do not damage the vehicle body.
Be sure to replace the back window glass spacer with a new one.