Home › Engine / Hybrid System › 2TR-FE (ENGINE CONTROL) › KNOCK SENSOR
RM2850E _51 Engine / Hybrid System _073287 2TR-FE ENGINE CONTROL _0356945 KNOCK SENSOR A

2TR-FE ENGINE CONTROL  KNOCK SENSOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 51405A 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 58410 5.REMOVE ENGINE SERVICE HOLE COVER

Hide 58734B 6.REMOVE REAR ENGINE SERVICE COVER WEATHERSTRIP

Hide 58521D 7.REMOVE ENGINE SERVICE HOLE COVER MAT

Hide 58420 8.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY

Hide 58123A 9.REMOVE SHIFT AND SELECT LEVER SUPPORT WITH BOOTS

Hide 33506F 10.REMOVE FLOOR SHIFT CONTROL SHIFT LEVER RETAINER SUB-ASSEMBLY

Hide 58701A 11.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY

Hide 17861 12.REMOVE INTAKE AIR CONNECTOR

Hide 22030 13.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

Hide 23271F 14.DISCONNECT FUEL HOSE

Hide 23807 15.REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY

Hide 23250 16.REMOVE FUEL INJECTOR ASSEMBLY

Hide 17111 17.REMOVE INTAKE MANIFOLD

a.
A147690

Separate the water by-pass hose from the intake manifold.


b.

Disconnect the No. 3 ventilation hose from the intake manifold.


c.

Disconnect the brake booster hose from the intake manifold.


d.
A110725

Disconnect the 2 wire harness clamps.


e.
A110726

Remove the bolt and remove the wire harness bracket.


f.
A177691

Remove the 5 bolts and 2 nuts and remove the intake manifold assembly.


g.

Remove the gasket from the intake manifold.


Hide 89615 18.REMOVE KNOCK SENSOR

a.
A430891

Disconnect the knock sensor connector.


b.

Remove the bolt and remove the knock sensor.