Home › Drivetrain › A861E (AUTOMATIC TRANSMISSION / TRANSAXLE) › AUTOMATIC TRANSMISSION SYSTEM › from 2019.08
RM2850E _52 Drivetrain _082622 A861E AUTOMATIC TRANSMISSION / TRANSAXLE _0398655 AUTOMATIC TRANSMISSION SYSTEM C

A861E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  P2764  Torque Converter Clutch Pressure Control Solenoid Control Circuit Low  


DESCRIPTION

Based on signals such as the vehicle speed, throttle opening angle, etc., the transmission control ECU assembly calculates the current and operates the transmission solenoid (SL3). Also the ECU verifies the amount of slippage during lock-up operation based on the engine speed and turbine speed signals, and controls slippage to achieve the optimum amount. When a lock-up signal is being output, if the engine speed signal and turbine speed signal do not match, the transmission control ECU assembly stores a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
P2764 Torque Converter Clutch Pressure Control Solenoid Control Circuit Low 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.

Lock-up operation signal being output

2.

Engine speed and turbine speed do not match

3.

5 seconds or more

4.

1 trip detection logic


·

Torque converter assembly

·

Automatic transmission assembly (Shift solenoid valve SL3)

·

Transmission control ECU assembly


O/D OFF Indicator Light: Blinking DTC stored

CONFIRMATION DRIVING PATTERN

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.



CAUTION / NOTICE / HINT

NOTICE:

Perform initialization when parts related to the automatic transmission are replaced.

Click hereDrivetrain>A861E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSMISSION SYSTEM>INITIALIZATION


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / ECT / Trouble Codes.


e.

Read the DTCs using the GTS.


Result:
Result Proceed to
Only DTC P2764 is output A
DTC P2764 and other DTCs are output B


HINT:

If any DTCs other than P2764 are output, perform troubleshooting for those DTCs first.



A

2.INSPECT TORQUE CONVERTER ASSEMBLY

B

2.INSPECT TORQUE CONVERTER ASSEMBLY

Result:
Proceed to
OK
NG



OK

NG