1.REMOVE NITROGEN OXIDES SENSOR
894A1
2.REMOVE PARTICULATE MATTER SENSOR
89425
3.REMOVE EXHAUST GAS TEMPERATURE SENSOR
17430
4.REMOVE EXHAUST TAILPIPE ASSEMBLY
Remove the 2 nuts, 2 bolts and exhaust tailpipe assembly.
Remove the gasket.
17420
5.REMOVE CENTER EXHAUST PIPE ASSEMBLY
Remove the 2 bolts, 3 nuts and center exhaust pipe assembly.
Remove the 2 gaskets.
18040A
6.REMOVE NO. 2 EXHAUST PIPE CONVERTER ASSEMBLY
Detach the 2 clamps and disconnect the wire harness.
Remove the 3 bolts and disconnect the No. 1 fuel tank heat insulator.
Remove the 2 bolts, 2 nuts and No. 2 exhaust pipe converter assembly.
Remove the 4 nuts, and then remove the exhaust pipe support cushion from the No. 2 exhaust pipe converter assembly and No. 2 exhaust pipe support bracket.
Remove the 2 nuts and exhaust pipe support cushion from the No. 2 exhaust pipe converter assembly.
17402
7.REMOVE FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY
Remove the 4 bolts, 2 nuts, No. 1 exhaust pipe heat insulator sub-assembly and No. 2 exhaust pipe heat insulator sub-assembly from the front No. 2 exhaust pipe sub-assembly.
Remove the 2 bols and 2 compression springs.
Remove the 3 bolts and front No. 2 exhaust pipe sub-assembly.
Remove the gasket from the front No. 2 exhaust pipe sub-assembly.
Remove the gasket from the front exhaust pipe sub-assembly.
18040
8.REMOVE NO. 1 EXHAUST PIPE CONVERTER ASSEMBLY
| *1 | No. 1 Air Hose |
| *2 | No. 2 Air Hose |
Slide the 2 hose clips and remove the No. 1 air hose.
Slide the 2 hose clips and remove the No. 2 air hose.
Detach the clamp.
Disconnect the connector from the urea injector assembly.
Remove the 3 nuts and urea injector assembly from the No. 1 exhaust pipe converter assembly.
Remove the gasket from the urea injector assembly.
Remove the 2 bolts, 2 nuts and No. 1 exhaust pipe converter assembly.
Remove the 4 nuts, and then remove the exhaust pipe support cushion from the No. 1 exhaust pipe converter assembly and No. 1 exhaust pipe support bracket.
Remove the 2 nuts and exhaust pipe support cushion from the No. 1 exhaust pipe converter assembly.
9.REMOVE NO. 3 TURBO INSULATOR
10.REMOVE NO. 2 TURBO INSULATOR
16028
11.DISCONNECT NO. 2 TURBO WATER PIPE SUB-ASSEMBLY AND NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY
19971G
12.REMOVE VACUUM PIPE
Disconnect the 2 vacuum hoses.
Remove the 2 bolts and vacuum pipe.
23811H
13.DISCONNECT NO. 1 FUEL PIPE
87378C
14.REMOVE EXHAUST PIPE
17410
15.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the 3 bolts and No. 1 exhaust pipe support bracket.
| *1 | Gasket |
| *2 | Spacer |
Remove the bolt, 2 nuts, 3 spacers and front exhaust pipe assembly.
Remove the gasket.