1.DRAIN ENGINE COOLANT
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
51442
3.REMOVE NO. 2 ENGINE UNDER COVER
11209
4.REMOVE V-BANK COVER SUB-ASSEMBLY
16470
5.REMOVE RADIATOR RESERVOIR TANK SUB-ASSEMBLY
6.REMOVE FRONT WIPER ARM HEAD CAP
85291A
7.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH
85291B
8.REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH
53866J
9.REMOVE FRONT FENDER TO COWL SIDE SEAL RH
53867H
10.REMOVE FRONT FENDER TO COWL SIDE SEAL LH
55781F
11.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
47202
12.REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY
13.REMOVE COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK
Remove the cowl top outer panel with windshield wiper motor and link (See page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>REMOVAL).
17705
14.REMOVE AIR CLEANER CAP
Disconnect the mass air flow meter connector and clamp [A].
Disconnect the ventilation hose [B].
Remove the hose band and air cleaner cap [C].
22210
15.REMOVE THROTTLE BODY
Disconnect the water by-pass hoses from the throttle body.
Disconnect the throttle position sensor and control motor connector.
Disconnect the wire harness clamp.
Remove the 4 bolts and the throttle body.
Remove the gasket from the intake air surge tank.