Home › Engine / Hybrid System › 2AZ-FE FUEL › FUEL PRESSURE PULSATION DAMPER
RM24M0E _51 Engine / Hybrid System _059542 2AZ-FE FUEL _0291798 FUEL PRESSURE PULSATION DAMPER A

2AZ-FE FUEL  FUEL PRESSURE PULSATION DAMPER  INSTALLATION  


PROCEDURE

Hide 23270 1.INSTALL FUEL PRESSURE PULSATION DAMPER ASSEMBLY

a.
A125339E01
1.263,0.152 1.774,0.385 0.511,0.234 10 O-Ring 2.992,1.42 3.142,1.176 false 3.142,1.176 3.142,0.259 false 3.148,0.259 1.841,0.259 false

Apply a light coat of gasoline or spindle oil to the O-ring of the fuel pressure pulsation damper.


b.
A125338

Install the fuel pressure pulsation damper with the 2 bolts.

Torque:
9.0 N*m (90 kgf*cm, 80 in.*lbf)

NOTICE:

Make sure that the O-ring is not cracked or jammed when installing it.



Hide 4.INSTALL COWL TOP OUTER PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

a.

Install the cowl top outer panel with windshield wiper motor and link (see page Vehicle Interior>WIPER / WASHER>FRONT WIPER MOTOR>INSTALLATION).


Hide 28800 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.