1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
11209
2.REMOVE V-BANK COVER ASSEMBLY
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
28800J
5.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
28800
6.REMOVE BATTERY
17751
7.REMOVE NO. 1 AIR CLEANER INLET
Remove the clip and inlet.
53510
8.REMOVE HOOD LOCK ASSEMBLY (for LHD)
53510
9.REMOVE HOOD LOCK ASSEMBLY (for RHD)
81175
10.REMOVE HEADLIGHT ASSEMBLY LH
81135
11.REMOVE HEADLIGHT ASSEMBLY RH
Use the same procedures for the RH side and LH side.
53209B
12.REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY
Disconnect the 3 wire harness clamps from the hood lock support brace sub-assembly.
Remove the 2 bolts and hood lock support brace sub-assembly.
16533
13.REMOVE RADIATOR SUPPORT UPPER BRACKET
Remove the 4 bolts and 2 brackets.
16712
14.REMOVE NO. 2 FAN SHROUD
Remove the 2 bolts and No. 2 fan shroud.
16268
15.REMOVE NO. 1 WATER BY-PASS PIPE
Detach the clamp from the radiator support.
Disconnect the No. 1 water by-pass hose from the reservoir.
Disconnect the No. 3 water by-pass hose from the radiator.
Disconnect the No. 1 radiator hose from the radiator.
Remove the 2 bolts and No. 1 water by-pass pipe from the upper radiator support.
89257
16.DISCONNECT COOLING FAN ECU CONNECTORS
Disconnect the No. 1 and No. 2 cooling fan ECU connectors.
53205
17.REMOVE RADIATOR UPPER SUPPORT SUB-ASSEMBLY
Remove the bolt securing the ground cable from the radiator support LH side.
Detach the 2 wire harness clamps from the radiator support LH side.
Remove the 4 bolts and support with wire harness.
Do not move the radiator upper support excessively, as its movement is limited by the wire harness.
16571C
18.DISCONNECT NO. 1 RADIATOR HOSE
Disconnect the No. 1 radiator hose from the radiator.
16572D
19.DISCONNECT NO. 2 RADIATOR HOSE
Disconnect the No. 2 radiator hose from the radiator.
32921
20.DISCONNECT NO. 1 OIL COOLER INLET TUBE
Disconnect the oil cooler hose inlet and outlet from the radiator.
Remove the 3 bolts and tube from the radiator.
88711A
21.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
88716A
22.DISCONNECT COOLER REFRIGERANT LIQUID PIPE
88460
23.REMOVE COOLER CONDENSER ASSEMBLY
16400
24.REMOVE RADIATOR ASSEMBLY WITH FAN SHROUD AND FAN MOTOR
Remove the radiator with fan shroud and fan motor.
Remove the 2 lower radiator support cushions.
16711
25.REMOVE FAN SHROUD WITH FAN MOTOR
Remove the 2 bolts and fan shroud with fan motor from the radiator.