1. PRECAUTION
Be sure to read "PRECAUTION" thoroughly before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at for 90 seconds after disconnecting the cable to prevent airbag deployment.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
55302A
3.REMOVE UPPER INSTRUMENT PANEL
Remove the upper instrument panel (see page Vehicle Interior>INTERIOR PANEL>UPPER INSTRUMENT PANEL>REMOVAL).
55312
4.REMOVE LOWER INSTRUMENT PANEL
Remove the lower instrument panel (see page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL).
5.DISCONNECT CONNECTOR
Disconnect the stop light switch connector.
with VSC:
Disconnect the brake pedal load sensing switch connector.
84340
6.REMOVE STOP LIGHT SWITCH ASSEMBLY
Turn the switch counterclockwise and remove it.
47264A
7.REMOVE PUSH ROD PIN
Remove the clip from the push rod pin.
Remove the push rod pin from the push rod clevis.
47110
8.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
Remove the bolt from the support.
Remove the 4 nuts and support.