Home › Brake › PARKING BRAKE › PARKING BRAKE CABLE › from 2016.05
RM24M0E _54 Brake _059559 PARKING BRAKE _0291887 PARKING BRAKE CABLE A

PARKING BRAKE  PARKING BRAKE CABLE  REMOVAL  


PROCEDURE

Hide 67914B 1.REMOVE FRONT DOOR SCUFF PLATE LH (for LHD)

Hide 67913B 2.REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

Hide 62112 3.REMOVE COWL SIDE TRIM BOARD LH (for LHD)

Hide 62111C 4.REMOVE COWL SIDE TRIM BOARD RH (for RHD)

Hide 55606 5.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432B 6.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (w/o Knee Airbag)

Hide 55432B 7.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER (w/ Knee Airbag)

Hide 9.REMOVE REAR WHEEL

Hide 10.REMOVE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 11.REMOVE REAR DISC

Hide 46430 12.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

a.

Disconnect the cable from the parking brake shoe lever (see page Brake>PARKING BRAKE>PARKING BRAKE ASSEMBLY>DISASSEMBLY).


b.
C133386

Remove the 2 bolts and disconnect the cable from the backing plate.


Hide 46420 13.DISCONNECT NO. 2 PARKING BRAKE CABLE ASSEMBLY

HINT:

Use the same procedures described for the No. 3 cable.


Hide 46341 14.REMOVE PARKING BRAKE EQUALIZER

a.
C367614

Disconnect the 3 cable ends and then remove the equalizer.


Hide 46356 15.REMOVE EQUALIZER SUPPORT BRACKET

a.
C367461

Remove the 4 bolts and bracket.


Hide 46430 16.REMOVE PARKING BRAKE CABLE ASSEMBLY

C133387E03
2.74,0.958 2.906,1.156 0.167,0.198 10 false A 6.448,4.76 6.615,4.958 0.167,0.198 10 true G 2.479,0.427 2.646,0.625 0.167,0.198 10 true A 2.156,1.156 2.323,1.354 0.167,0.198 10 false B 2.917,0.177 3.083,0.375 0.167,0.198 10 false C 6.5,3.281 6.667,3.479 0.167,0.198 10 true D 6.573,1.813 6.708,2.01 0.135,0.198 10 true E 2.833,4.625 2.938,4.792 0.104,0.167 10 true H 1.396,3.49 1.563,3.688 0.167,0.198 10 true F

a.

Remove the No. 2 parking brake cable as follows.

i.

Remove the 2 clamp bolts (labeled A) and parking brake cable No. 1 support bracket (labeled B) from the crossmember.


ii.

Remove the parking brake cable guide RH (labeled C) from the crossmember.


iii.

Remove the clamp bolt (labeled D) from the beam bracket.


iv.

Remove the clamp bolt (labeled E) from the beam bracket.



b.

Remove the No. 3 parking brake cable as follows.

i.

Remove the clamp bolt (labeled F) from the crossmember.


ii.

Remove the clamp bolt (labeled G) from the beam bracket.


iii.

Remove the clamp bolt (labeled H) from the beam bracket.