Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
84306
1.INSTALL SPIRAL CABLE
Align the locating pins, attach the 6 claws and install the spiral cable.
84306
2.INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
Attach the 3 claws and install the spiral cable with steering angle sensor.
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
Connect the connectors to the spiral cable.
When handling the airbag connector, do not damage the airbag wire harness.
45286
3.INSTALL STEERING COLUMN COVER
84306
4.POSITION SPIRAL CABLE
Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
Do not use the airbag wire harness to turn the spiral cable.
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
Do not use the airbag wire harness to turn the spiral cable.
The spiral cable will rotate approximately 2.5 turns to the left and right from the center.
45100
5.INSTALL STEERING WHEEL ASSEMBLY
45130
6.INSTALL STEERING PAD ASSEMBLY
28800
7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
45130
8.INSPECT STEERING PAD ASSEMBLY
9.PERFORM INITIALIZATION
Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
10.CHECK SRS WARNING LIGHT
Check the SRS warning light (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).
45100
11.INSPECT STEERING WHEEL POSITION