Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
84306
1.INSTALL SPIRAL CABLE SUB-ASSEMBLY
Align the locating pins, attach the 6 claws and install the spiral cable sub-assembly.
2.INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
Check that the front wheels are facing straight ahead.
Set the turn signal switch to the neutral position.
Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
Attach the 3 claws and install the spiral cable with steering angle sensor.
When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
Connect the connectors to the spiral cable.
When handling the airbag connector, do not damage the airbag wire harness.
45286
3.INSTALL STEERING COLUMN COVER
for LHD: (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for LHD)>INSTALLATION)
for RHD: (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for RHD)>INSTALLATION)
84306
4.POSITION SPIRAL CABLE
Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
Do not use the airbag wire harness to turn the spiral cable.
Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
Do not use the airbag wire harness to turn the spiral cable.
The spiral cable will rotate approximately 2.5 turns to the left and right from the center.
45100
5.INSTALL STEERING WHEEL ASSEMBLY
for LHD: (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for LHD)>INSTALLATION)
for RHD: (See page Steering>STEERING COLUMN>STEERING COLUMN ASSEMBLY(for RHD)>INSTALLATION)
45100
6.INSPECT STEERING WHEEL POSITION
45130
7.INSTALL STEERING PAD ASSEMBLY
for LHD: (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD(for LHD)>INSTALLATION)
for RHD: (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>STEERING PAD(for RHD)>INSTALLATION)