Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › DRIVER SIDE KNEE AIRBAG ASSEMBLY › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291901 DRIVER SIDE KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  DRIVER SIDE KNEE AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 55350 1.INSTALL INSTRUMENT PANEL BRACE ASSEMBLY

a.
C139025

Install the brace with the bolt.


Hide 73900 2.INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.
C136825

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Install the knee airbag with the 4 bolts.

Torque:
10 N*m (101 kgf*cm, 7 ft.*lbf)


Hide 55432B 3.INSTALL INSTRUMENT PANEL FINISH PANEL LOWER

Hide 55606 4.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 62112 5.INSTALL COWL SIDE TRIM BOARD LH

Hide 67914B 6.INSTALL FRONT DOOR SCUFF PLATE LH

Hide 55441 8.INSTALL NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 55650 9.INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55411G 10.INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY

Hide 28800 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 12.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 13.CHECK SRS WARNING LIGHT