Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › DRIVER SIDE KNEE AIRBAG ASSEMBLY › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291901 DRIVER SIDE KNEE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  DRIVER SIDE KNEE AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 28800 1.DISCONNECT CABLE FROM NEGATIVE BATTERYTERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 55411G 2.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY

Hide 55650 3.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 55441 4.REMOVE INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY

Hide 67914B 6.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 62112 7.REMOVE COWL SIDE TRIM BOARD LH

Hide 55606 8.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55432B 9.REMOVE INSTRUMENT PANEL FINISH PANEL LOWER

Hide 73900 10.REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY

a.
C136825

Remove the 4 bolts and knee airbag.


b.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 55350 11.REMOVE INSTRUMENT PANEL BRACE ASSEMBLY

a.
C139025

Remove the bolt and brace from the reinforcement.