Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CENTER FLOOR AIRBAG SENSOR › 2013.04–2016.05
RM24M0E _58 Vehicle Interior _059562 SUPPLEMENTAL RESTRAINT SYSTEMS _0291910 CENTER FLOOR AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  CENTER FLOOR AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


PROCEDURE

Hide 1.INSTALL CENTER FLOOR AIRBAG SENSOR

a.
C137830

Install the clip.


b.

Install the sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 82 in.*lbf)

NOTICE:
·

If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.

·

When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.




c.

Check that there is no looseness in the installation parts of the sensor.


d.

Connect the sensor connector.


Hide 2.INSTALL CENTER FLOOR AIRBAG SENSOR COVER

a.

Attach the 2 claws to install the sensor cover.


Hide 3.INSTALL FRONT SEAT ASSEMBLY LH

a.

for Manual Seat:

Install the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION).


b.

for Power Seat:

Install the front seat (see page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION).


Hide 28800 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 5.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 6.CHECK SRS WARNING LIGHT