Home › Vehicle Interior › LIGHTING › HEADLIGHT ASSEMBLY(except LED Headlight) › from 2016.05
RM24M0E _58 Vehicle Interior _059564 LIGHTING _0291940 HEADLIGHT ASSEMBLY(except LED Headlight) A

LIGHTING  HEADLIGHT ASSEMBLY(except LED Headlight)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 81150 1.INSTALL HEADLIGHT ASSEMBLY

a.

Connect each connector.


b.

Engage the claw.


c.

Install the headlight assembly with the 3 screws.

Torque:
2.5 N*m (26 kgf*cm, 22 in.*lbf)


Hide 2.INSTALL FRONT BUMPER ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ AFS)

Hide 4.PERFORM INITIALIZATION (w/ AFS)

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



Hide 5.ADJUST HEADLIGHT AIMING

Hide 6.ADJUST FOG LIGHT AIMING

a.

Adjust fog light aiming (See page Vehicle Interior>LIGHTING>FOG LIGHT ASSEMBLY>ADJUSTMENT).