Home › Drivetrain › K112 (CVT) › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2016.05
RM24M0E _52 Drivetrain _059572 K112 CVT _0292047 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K112 CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P1586  Acceleration Sensor Malfunction  


DESCRIPTION

The ECM determines the vehicle inclination based on a signal from the yaw rate sensor.

HINT:

If a CAN communication DTC is output, perform troubleshooting for that DTC first.


DTC No. DTC Detection Condition
1.

Diagnosis Condition

2.

Malfunction Status

3.

Malfunction Time

4.

Other


Trouble Area
P1586
1.

The engine switch is on (IG).

2.

With a vehicle speed of 30 km/h (18 mph) or more, the difference between the longitudinal acceleration calculated based on the G sensor value and the longitudinal acceleration calculated based on the vehicle speed exceeds 0.35 G for 60 seconds or more.

3.

3.0 seconds

4.

1 trip detection logic


·

Yaw rate sensor

·

Brake actuator assembly (Skid control ECU)

·

CAN communication system


1.

The engine switch is on (IG).

2.

No change detected in the G sensor signal 16 times or more while the vehicle speed decreases from 30 km/h (18 mph) to 0 km/h (0 mph).

3.

3.0 seconds

4.

1 trip detection logic



WIRING DIAGRAM

PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)

A

2.CHECK DTC OUTPUT (IN ADDITION TO DTC P1586)

B

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)

2.CHECK DTC OUTPUT (IN ADDITION TO DTC P1586)

b.

Perform a road test where the vehicle is driven at 30 km/h (18 mph) or more, the brakes are applied at least 16 times and the vehicle is finally stopped.


c.

Connect the intelligent tester to the DLC3.


d.

Turn the engine switch on (IG).


e.

Turn the intelligent tester on.


f.

Enter the following menus: Powertrain / Engine and ECT / DTC.


g.

Read the DTCs using the tester.

Result
Result Proceed to
Only P1586 is output A
P1586 and other DTCs are output B

HINT:

If any other DTCs besides DTC P1586 are output, perform troubleshooting for those DTCs first.




A

3.READ VALUE USING INTELLIGENT TESTER (G SENSOR)

B

3.READ VALUE USING INTELLIGENT TESTER (G SENSOR)

A

4.REPLACE YAW RATE SENSOR

B

REPLACE BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)

4.REPLACE YAW RATE SENSOR

NEXT

5.PERFORM INITIALIZATION