Home › Drivetrain › K112 (CVT) › SPEED SENSOR
RM24M0E _52 Drivetrain _059572 K112 CVT _0292057 SPEED SENSOR A

K112 CVT  SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89413B 1.INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT)

a.

Coat a new O-ring with CVT Fluid FE and install it to the transmission revolution sensor (NOUT).


b.

Install the transmission revolution sensor (NOUT) to the continuously variable transaxle with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NOUT) connector.


d.

Connect the engine wire to the wire harness clamp bracket.


e.

Install the ground cable to the continuously variable transaxle with the bolt.

Torque:
8.4 N*m (86 kgf*cm, 74 in.*lbf)


Hide 89413B 2.INSTALL TRANSMISSION REVOLUTION SENSOR (NIN)

a.

Coat a new O-ring with CVT Fluid FE and install it to the transmission revolution sensor (NIN).


b.

Install the transmission revolution sensor (NIN) to the continuously variable transaxle with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NIN) connector.


Hide 89413B 3.INSTALL TRANSMISSION REVOLUTION SENSOR (NT)

a.

Coat a new O-ring with CVT Fluid FE and install it to the transmission revolution sensor (NT).


b.

Install the transmission revolution sensor (NT) to the continuously variable transaxle with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


c.

Connect the transmission revolution sensor (NT) connector.


Hide 55712 7.INSTALL FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR AND LINK

Hide 53292A 9.INSTALL UPPER RADIATOR SUPPORT SEAL