Home › Engine / Hybrid System › 2GR-FE STARTING › ENGINE SWITCH › from 2016.05
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292071 ENGINE SWITCH A

2GR-FE STARTING  ENGINE SWITCH  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55420A 2.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY (for LHD)

Hide 55414A 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (for LHD, w/o Navigation System)

Hide 4.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for LHD, for Navigation Receiver Type)

Hide 55660 5.REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55042B 6.REMOVE NO. 2 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for LHD)

Hide 55650 7.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55041B 8.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for LHD)

Hide 55474B 9.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH (for LHD)

Hide 89611 10.REMOVE ENGINE SWITCH (for LHD)

a.
A387633

Disengage the 2 claws and remove the engine switch.


Hide 33504F 11.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for RHD)

Hide 55420A 12.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

Hide 55041B 13.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)

Hide 14.REMOVE ENGINE SWITCH (for RHD)

a.
A383269

Disengage the 2 claws and remove the engine switch.