Home › Engine / Hybrid System › 2GR-FE STARTING › PUSH-BUTTON START › 2014.09–2016.05
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292073 PUSH-BUTTON START T

2GR-FE STARTING  PUSH-BUTTON START  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or Replace faulty parts or perform adjustments as necessary.

·

Inspect the fuses and relays related to the system before inspecting the suspected areas below.



Push-button Start
Symptom Suspected Area See page
Power does not turn on (neither ACC nor IG is possible). Fuse (Click here)
Engine Switch -
Wire Harness or Connector -
Main Body ECU (Instrument Panel Junction Block LH) -
Certification ECU -
ID Code Box -
Power is not turned on (only ACC is not turned on). Fuse (Click here)
Instrument Panel Junction Block RH -
Wire Harness or Connector -
Main Body ECU (Instrument Panel Junction Block LH) -
Power is not turned on (only IG is not turned on). Fuse (Click here)
Instrument Panel Junction Block RH -
IG2 Relay -
Wire Harness or Connector -
Main Body ECU (Instrument Panel Junction Block LH) -
Engine does not start. Engine Switch (Click here)
Shift Lock Control ECU -
STOP Fuse -
Stop Light Switch -
Electrical Steering Lock Function -
ST CUT Relay -
Park/Neutral Position Switch -
ST Relay -
ECM -
Engine Immobiliser System -
Main Body ECU (Instrument Panel Junction Block LH) -
Wire Harness or Connector -
Engine switch indicator light does not come on. Engine Switch Indicator Light Circuit (Click here)
Room oscillator does not recognize key Indoor electrical key oscillator (for front) (Click here)
Indoor electrical key oscillator (for rear1) -
Indoor electrical key oscillator (for rear2) -
Certification ECU -
Electrical key -
Wire harness -
Entry interior alarm does not sound Combination meter (Click here)
Certification ECU -