Home › Engine / Hybrid System › 2AZ-FE STARTING › PUSH-BUTTON START › 2013.04–2016.05
RM24M0E _51 Engine / Hybrid System _059575 2AZ-FE STARTING _0292081 PUSH-BUTTON START T

2AZ-FE STARTING  PUSH-BUTTON START  PROBLEM SYMPTOMS TABLE  


HINT:

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Push-button start
Symptom Suspected Area See page
Power source mode does not change Engine switch indicator circuit (Click here)
Room oscillator does not recognize key -
Engine switch -
Electrical key -
ID code box -
Main body ECU -
Wire harness -
Engine does not start Push-button start function DTCs (Click here)
Power source mode does not change -
Engine immobiliser system -
Steering lock system -
SFI system -
Engine switch -
Park / Neutral position switch (for U241E) -
Park / Neutral position switch (for K112) -
Stop light switch -
Main body ECU -
Wire harness -
Room oscillator does not recognize key Indoor electrical key oscillator (for front) (Click here)
Indoor electrical key oscillator (for rear1) -
Indoor electrical key oscillator (for rear2) -
Certification ECU -
Electrical key -
Wire harness -
Entry interior alarm does not sound Combination meter (Click here)
Certification ECU -
Engine switch indicator circuit Main body ECU (Click here)
Engine switch -
Wire harness -