Home › Drivetrain › AXLE › REAR AXLE HUB › 2013.04–2014.09
RM24M0E _52 Drivetrain _059581 AXLE _0292140 REAR AXLE HUB A

AXLE  REAR AXLE HUB  INSTALLATION  


PROCEDURE

Hide 42440 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.
C136807

Install the axle hub and bearing to the axle carrier with the 4 bolts.

Torque:
90 N*m (918 kgf*cm, 66 ft.*lbf)

NOTICE:

Do not place the hub and bearing's magnet rotor side so that it is facing downward, and do not allow the magnet rotor side to become damaged or contact foreign matter.



Hide 42431 3.INSTALL REAR DISC

Hide 47750A 4.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

a.
A137317

Install the caliper with 2 bolts.

Torque:
88 N*m (900 kgf*cm, 65 ft.*lbf)


Hide 5.INSTALL REAR WHEEL

T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }

Hide 6.INSPECT REAR WHEEL ALIGNMENT

a.

Inspect the rear wheel alignment (see page Suspension>SUSPENSION>REAR WHEEL ALIGNMENT>ADJUSTMENT).


Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See Page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.CHECK SPEED SENSOR SIGNAL