Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292155 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


PROCEDURE

Hide 89245B 1.INSTALL STEERING ANGLE SENSOR

a.
C130718

Align the locating pins, attach the 6 claws and install the sensor to the spiral cable.


Hide 84306 2.INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

Hide 45100 3.INSTALL STEERING WHEEL ASSEMBLY

Hide 5.INSPECT STEERING WHEEL CENTER POINT

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
·

When reconnecting the cable to the negative (-) battery terminal after installing the steering angle sensor, check that the front tires and steering wheel are kept aligned straight ahead before and after connecting the cable to the negative (-) battery terminal.

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 8.CHECK SRS WARNING LIGHT