This DTC is set when there is a tire size abnormality or when foreign matter is attached to the speed sensor tip or the sensor rotor.
The skid control ECU determines whether foreign matter is present, through the pulse signals transmitted by the sensor.
This DTC may be set due to defects in the connector terminal or wire harness of the speed sensor circuit.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1237/37 | When any of following (1 to 3) detected:
1. Discrepancy among four wheel speed sensor output. 2. Abnormal pulse signals from 3 or more sensors. 3. Continuous ABS control for 60 seconds or more. |
·
Speed sensor rotor ·
Speed sensor ·
Speed sensor circuit ·
Tire & wheel size |
Check the diameters of all 4 tires.
Diameters of all 4 tires are equal.
OK
NG
Remove the drive shaft, and check around the speed sensor rotor.
No scratches or foreign matter on the sensor tip.
OK
NG
Check the front speed sensor circuit (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C0200/31).
Check the rear speed sensor circuit (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C0210/33).
OK
NG
Check the front speed sensor circuit (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C0200/31).
Check the rear speed sensor circuit (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C0210/33).
OK
NG
Clear the DTCs (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Drive the vehicle at more than 20 km/h (12 mph) for more than 60 seconds.
Check if the same DTC(s) is output (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC is output (for 2AZ-FE) | A |
| DTC is output (for 2GR-FE) | B |
| DTC is not output | C |
A
B
C