Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(for 2AZ-FE without VSC) › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292159 BRAKE ACTUATOR(for 2AZ-FE without VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(for 2AZ-FE without VSC)  INSTALLATION  


PROCEDURE

Hide 44510 1.INSTALL BRAKE ACTUATOR ASSEMBLY WITH BRACKET

NOTICE:

Do not remove the hole plugs before connecting the brake lines. New actuators are filled with brake fluid.


a.
C130693

Install the brake actuator assembly with bracket with the 3 nuts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)

NOTICE:

Be careful not to damage the brake lines.



b.
C133748

Connect the brake tube clamp to the bracket.


c.
C133749

Connect the connector and push the lock lever downward.


Hide 2.CONNECT BRAKE TUBES

a.
C130691E02
2.208,3.302 2.542,4.094 2.542,4.094 2.698,2.875 true 1.927,1.802 2.042,1.708 false 1.698,1.479 1.969,1.281 false 1.479,1.115 1.781,0.833 false 1.271,0.708 1.552,0.406 false 2.083,1.604 3.177,1.792 1.094,0.188 10 false Front Wheel RH 1.833,0.729 2.875,0.917 1.042,0.188 10 false Rear Wheel RH 2.01,1.167 3.042,1.354 1.031,0.188 10 false Rear Wheel LH 2.094,4.135 3.167,4.375 1.073,0.24 10 false Master Cylinder 1.594,0.323 2.615,0.51 1.021,0.188 10 false Front Wheel LH

Using SST, connect the 6 brake lines to the correct locations on the actuator, as shown in the illustration.

SST
09023-00101  

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

without SST

14 N*m (144 kgf*cm, 10 ft.*lbf)

with SST


HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

·

This torque value is effective when SST is parallel to a torque wrench.




Hide 3.BLEED BRAKE SYSTEM

Hide 17700 4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY

Hide 74431 6.INSTALL BATTERY TRAY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 9.CHECK BRAKE ACTUATOR ASSEMBLY WITH INTELLIGENT TESTER