Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(for 2GR-FE) › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292161 BRAKE ACTUATOR(for 2GR-FE) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(for 2GR-FE)  INSTALLATION  


PROCEDURE

Hide 44540 1.INSTALL ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET

NOTICE:

Do not remove the hole plugs before connecting the brake lines. New actuators are filled with brake fluid.


a.
C130700

Install the ABS and traction actuator assembly with bracket with the 3 nuts.

Torque:
19 N*m (194 kgf*cm, 14 ft.*lbf)

NOTICE:

Be careful not to damage the brake lines.



b.
C133750

Connect the brake tube clamp to the bracket.


c.
C130703

Connect the connector and push the lock lever downward.


Hide 2.CONNECT BRAKE LINES

a.
C130698E02
1.177,0.531 1.417,0.219 false 1.385,0.917 1.708,0.625 false 1.594,1.219 1.896,1.052 false 1.823,1.521 1.979,1.479 false 2.188,2.875 2.646,4.021 2.646,4.021 2.646,2.667 true 1.458,0.104 2.563,0.281 1.104,0.177 10 false Front Wheel LH 2.031,1.396 3.135,1.573 1.104,0.177 10 false Front Wheel RH 1.938,0.948 3.042,1.125 1.104,0.177 10 false Rear Wheel LH 1.75,0.531 2.854,0.708 1.104,0.177 10 false Rear Wheel RH 2.188,4.063 3.229,4.281 1.042,0.219 10 false Master Cylinder

Using SST, connect the 6 brake lines to the correct locations on the actuator, as shown in the illustration.

SST
09023-00101  
09023-38201  

Torque:
for Front/Rear Wheel Port : 15 N*m (155 kgf*cm, 11 ft.*lbf)

without SST

14 N*m (144 kgf*cm, 10 ft.*lbf)

with SST


Torque:
for Master Cylinder Port : 20 N*m (199 kgf*cm, 14 ft.*lbf)

without SST

18 N*m (185 kgf*cm, 13 ft.*lbf)

with SST


HINT:
·

Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

·

This torque value is effective when SST is parallel to a torque wrench.




Hide 3.BLEED BRAKE SYSTEM

Hide 6.INSTALL FRONT COWL TOP OUTSIDE PANEL WITH WINDSHIELD WIPER MOTOR LINK

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 8.CHECK ABS AND TRACTION ACTUATOR ASSEMBLY WITH INTELLIGENT TESTER

a.

Check the ABS and traction actuator with the intelligent tester (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for 2GR-FE)>ON-VEHICLE INSPECTION).