44540
1.INSTALL ABS AND TRACTION ACTUATOR ASSEMBLY WITH BRACKET
Do not remove the hole plugs before connecting the brake lines. New actuators are filled with brake fluid.
Install the ABS and traction actuator assembly with bracket with the 3 nuts.
Be careful not to damage the brake lines.
Connect the brake tube clamp to the bracket.
Connect the connector and push the lock lever downward.
2.CONNECT BRAKE LINES
Using SST, connect the 6 brake lines to the correct locations on the actuator, as shown in the illustration.
without SST
with SST
without SST
with SST
Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
This torque value is effective when SST is parallel to a torque wrench.
3.BLEED BRAKE SYSTEM
(See page Brake>BRAKE>BRAKE FLUID>BLEEDING)
17700
4.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17705
5.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
74431
6.INSTALL BATTERY TRAY
28800
7.INSTALL BATTERY
8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
9.CHECK ABS AND TRACTION ACTUATOR ASSEMBLY WITH INTELLIGENT TESTER
Check the ABS and traction actuator with the intelligent tester (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for 2AZ-FE with VSC)>ON-VEHICLE INSPECTION).