Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292164 VSC OFF SWITCH A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55420A 3.REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER ASSEMBLY (for LHD)

Hide 55414A 4.REMOVE INSTRUMENT CLUSTER FINISH PANEL END (for LHD)

Hide 5.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for LHD)

Hide 55650 6.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY (for LHD)

Hide 55041B 7.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for LHD)

Hide 55446A 8.REMOVE NO. 1 SWITCH HOLE BASE (for LHD)

Hide 84988L 9.REMOVE VSC OFF SWITCH (for LHD)

a.
C285673

Disengage the 2 claws and remove the VSC OFF switch from the No. 1 switch hole base.


Hide 33504F 10.REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for RHD)

Hide 11.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY (for RHD)

Hide 55041B 12.REMOVE NO. 1 INSTRUMENT PANEL BOX DOOR SUB-ASSEMBLY (for RHD)

Hide 55446A 13.REMOVE NO. 1 SWITCH HOLE BASE (for RHD)

HINT:

Use the same procedure as for LHD. (See page Vehicle Interior>INTERIOR PANEL>LOWER INSTRUMENT PANEL>REMOVAL)


Hide 84970 14.REMOVE VSC OFF SWITCH (COMBINATION SWITCH ASSEMBLY) (for RHD)

a.
C352599

Disengage the 2 claws and remove the VSC OFF switch (combination switch assembly) from the No. 1 switch hole base.