Home › Vehicle Interior › AIR CONDITIONING › CONDENSER › from 2016.05
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292176 CONDENSER A

AIR CONDITIONING  CONDENSER  INSTALLATION  


PROCEDURE

Hide 88474 1.INSTALL COOLER DRYER

a.
E050386

Using pliers, install the cooler dryer.


b.
E357775

Apply a sufficient amount of compressor oil to the contact surfaces of a new O-ring and the cap.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring to the cap.


d.
I030086

Using a 14 mm socket hexagon wrench, install the cap to the modulator.

Torque:
2.9 N*m (29 kgf*cm, 25 in.*lbf)


Hide 88460 2.INSTALL COOLER CONDENSER ASSEMBLY

a.
H102257

Install the cooler condenser.


Hide 16712 3.INSTALL NO. 2 FAN SHROUD

H102255

a.

Install the fan shroud with the 2 bolts.

Torque:
11 N*m (112 kgf*cm, 8 ft.*lbf)


Hide 16533 4.INSTALL RADIATOR SUPPORT UPPER BRACKET

H102254

a.

Install the 2 brackets with the 4 bolts.

Torque:
19 N*m (193 kgf*cm, 14 ft.*lbf)


Hide 88716A 5.INSTALL COOLER REFRIGERANT LIQUID PIPE

H102253

a.

Remove the attached vinyl tape from the pipe and the connecting part of the cooler condenser.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the pipe joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the cooler refrigerant liquid pipe.


d.

Install the cooler refrigerant liquid pipe on the cooler condenser with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 88711 6.INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

H102252

a.

Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.


b.

Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

Compressor oil:

ND-OIL 8 or equivalent



c.

Install the O-ring on the cooler refrigerant discharge hose.


d.

Install the cooler refrigerant discharge hose on the cooler condenser with the bolt.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 81150 7.INSTALL HEADLIGHT ASSEMBLY LH (except LED Headlight)

Hide 8.INSTALL HEADLIGHT ASSEMBLY LH (for LED Headlight)

Hide 81110 9.INSTALL HEADLIGHT ASSEMBLY RH (except LED Headlight)

HINT:

Use the same procedure as for the LH side.


Hide 10.INSTALL HEADLIGHT ASSEMBLY RH (for LED Headlight)

HINT:

Use the same procedure as for the LH side.


Hide 11.INSTALL FRONT BUMPER ASSEMBLY (for Standard)

Hide 12.INSTALL FRONT BUMPER ASSEMBLY (for Sport Package)

Hide 13.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 14.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

Hide 17.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable to the negative (-) battery terminal.