Home › Vehicle Interior › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM
RM24M0E _58 Vehicle Interior _059586 ENGINE IMMOBILISER _0292196 ENGINE IMMOBILISER SYSTEM Y

ENGINE IMMOBILISER  ENGINE IMMOBILISER SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the engine immobiliser system.

·

*: Use the intelligent tester.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CRANK ENGINE FOR MORE THAN 10 SECONDS
3.CRANK ENGINE FOR MORE THAN 10 SECONDS
Result:
Proceed to
NEXT



NEXT

4.CHECK FOR DTC*
4.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output (See page Vehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).


b.

Clear the DTC.


c.

Recheck for DTCs. Based on the DTCs output above, try to cause the output of the same SFI system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

Result:
Result Proceed to
DTC output does not reoccur A
SFI system DTC output reoccurs B
Engine immobiliser system DTC output reoccurs C




A

5.PROBLEM SYMPTOMS TABLE

B

GO TO SFI SYSTEM

C

7.ADJUST, REPAIR OR REPLACE
5.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END