2011-2016 FJ Cruiser · Service Manual BRAKE

ABS Warning Light Remains ON

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 from Aug 2011

DESCRIPTION

If any of the following is detected, the ABS warning light remains ON.
  1. The skid control ECU connectors are disconnected from the skid control ECU.
  2. There is a malfunction in the skid control ECU internal circuit.
  3. There is an open in the harness between the combination meter and skid control ECU.

WIRING DIAGRAM

C164946E01

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK DTC
  1. Check if DTCs for ABS are recorded (Click here).


Result:
Result
Proceed to
DTC not output
A
DTC output
B



B
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
A


2. INSPECT SKID CONTROL ECU CONNECTOR
  1. Check that the ECU connector is securely connected.

OK:
The connector is securely connected.



NG
CONNECT CONNECTOR CORRECTLY
OK


3. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135293E01
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-29 (WA) - E13-17 (ESC)
    Below 1 Ω

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    A4-29 (WA) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

OK:
Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← U0073/94 Control Module Communication Bus OFF (+ U0100/65, U0123/62, U0124/95, U0126/63) (Aug 2009 – Oct 2010)ABS Warning Light Remains ON (Aug 2009 – Oct 2010) →