TC and CG Terminal Circuit
Circuit diagnosis · Vehicles built Jul 2007 – Jul 2008
Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012
DESCRIPTION
Connecting terminals TC and CG of the DLC3 causes the ECU to display 2-digit DTCs by blinking the ABS and VSC TRC warning lights.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform the zero point calibration (Click here).
| 1. INSPECT DLC3 TERMINAL VOLTAGE (TC) |
 |
- Turn the ignition switch to ON.
Measure the voltage.
- Standard voltage:
Tester Connection
|
Specified Condition
|
E1-13 (TC) - E1-4 (CG)
|
11 to 14 V
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. CHECK CAN COMMUNICATION SYSTEM |
 |
Check whether CAN communication DTC(s) is output (Click here).
- Result:
Result
|
Proceed to
|
DTC not output
|
A
|
DTC output
|
B
|
|
B |
 |
|
|
|
| A |
|
 |
|
|
| 3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) |
 |
- Measure the resistance.
- Standard resistance:
Tester Connection
|
Specified Condition
|
E1-4 (CG) - Body ground
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 4. CHECK HARNESS AND CONNECTOR (ECM - DLC3) |
 |
- Disconnect the ECM connector.
Measure the resistance.
- Standard resistance:
Tester Connection
|
Specified Condition
|
E47-23 (TC) - E1-13 (TC)
|
Below 1 Ω
|
E1-13 (TC) - Body ground
|
10 kΩ or higher
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| 5. CHECK ECM (DLC3 INPUT) |
 |
- Connect terminals TC and CG of the DLC3.
Turn the ignition switch to ON.
Check that the MIL is blinking.
- OK:
- MIL is blinking.
|
NG |
 |
|
|
|
| OK |
|
 |
|
|