2011-2016 FJ Cruiser · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 from Aug 2012

DESCRIPTION

w/o VSC OFF Switch:
Connecting terminals TC and CG of the DLC3 causes the ECU to display 2-digit DTCs by blinking the ABS and VSC TRC warning lights.
w/ VSC OFF Switch:
Connecting terminals TC and CG of the DLC3 causes the ECU to display 2-digit DTCs by blinking the ABS warning light and SLIP indicator light.

WIRING DIAGRAM

C216766E02

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform the zero point calibration (Click here).


1. INSPECT DLC3 TERMINAL VOLTAGE (TC)

  1. C146309E35
    Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E1-13 (TC) - E1-4 (CG)
    Ignition switch ON
    11 to 14 V

    Text in Illustration 
    *1
    Front view of DLC3



NG
Go to step 3
OK


2. CHECK CAN COMMUNICATION SYSTEM
  1. Check whether CAN communication DTC(s) is output (Click here).

    Result 
    Result
    Proceed to
    DTC not output
    A
    DTC output
    B



B
REPAIR CAN COMMUNICATION SYSTEM (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)

3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E1-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (ECM - DLC3)
  1. Disconnect the ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E81-28 (TC) - E1-13 (TC)
    Always
    Below 1 Ω
    E1-13 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5. INSPECT ECM (DLC3 INPUT)
  1. Connect terminals TC and CG of the DLC3.

  1. Turn the ignition switch to ON.

  1. Check that the MIL is blinking.

    OK:
    MIL is blinking.



NG
REPLACE ECM (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← TC and CG Terminal Circuit (Aug 2008 – Jul 2009)TC and CG Terminal Circuit (Nov 2010 – Jul 2011) →