When replacing the master cylinder solenoid, perform zero point calibration (Click here).
1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the following menu items: Chassis / ABS/VSC/TRC/ Active TestSelect the "SLIP Indicator Light" in the Active Test and operate the SLIP indicator light using the intelligent tester.
ACTIVE TEST: ABS/VSC/TRC
Tester Display
Test Part
Control Range
Diagnostic Note
Slip Indicator Light
SLIP indicator light
SLIP indicator light ON or OFF
Observe combination meter
Check that the SLIP indicator light turns on and off in the combination meter using the intelligent tester.
OK:
The SLIP indicator light turns ON and OFF in accordance with the intelligent tester operation.