2011-2016 FJ Cruiser · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

WIRING DIAGRAM

Click here

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select the following menu items: Chassis / ABS/VSC/TRC/ Active TestSelect the "SLIP Indicator Light" in the Active Test and operate the SLIP indicator light using the intelligent tester.

    ACTIVE TEST: ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Light
    SLIP indicator light
    SLIP indicator light ON or OFF
    Observe combination meter

  1. Check that the SLIP indicator light turns on and off in the combination meter using the intelligent tester.

    OK:
    The SLIP indicator light turns ON and OFF in accordance with the intelligent tester operation.



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135294E04
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-34 (IND) - E14-7 (SLIP)
    Always
    Below 1 Ω
    A4-34 (IND) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← Slip Indicator Light does not Come ON (Aug 2008 – Jul 2009)Slip Indicator Light does not Come ON (Nov 2010 – Jul 2011) →