2011-2016 FJ Cruiser · Service Manual BRAKE

Slip Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Aug 2011 – Jul 2012

Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

DESCRIPTION

Refer to Slip Indicator Light Remains ON (Click here).

WIRING DIAGRAM

Refer to Slip Indicator Light Remains ON (Click here).

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform calibration (Click here).


1. CHECK DTC
  1. Check for DTCs (Click here).

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



NG
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS
OK


2. CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)
OK


3. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (INDICAT. LAMP SLIP)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Body / Combination Meter / Active Test.

  1. According to the display on the tester, perform the Active Test.

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Slip
    Slip indicator light
    OFF/ON
    Perform the test with the vehicle stopped and the engine idling.

    OK:
    The slip indicator light turns ON or OFF according to the tester operations.



NG
Go to step 4
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)

4. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (SLIP INDICATOR LIGHT)
  1. Turn the ignition switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / ABS/VSC/TRC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Slip Indicator Light
    Slip indicator light
    Indicator light OFF/ON
    Observe the combination meter.

  1. Using the tester, check that the Data List display changes from OFF to ON.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Slip Indicator Light
    Slip indicator light/ ON or OFF
    ON: Indicator light on
    OFF: Indicator light off
    -

    OK:
    Data List display changes from OFF to ON



NG
REPLACE MASTER CYLINDER SOLENOID (Click here)
OK

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)


← Slip Indicator Light does not Come ON (Nov 2010 – Jul 2011)Slip Indicator Light does not Come ON (Aug 2012 – Oct 2012) →