2011-2016 FJ Cruiser · Service Manual BRAKE

C1251/51 Open in Pump Motor Circuit

Diagnostic trouble codes · Vehicles built Jul 2007 – Oct 2010

DESCRIPTION

The motor relay (semiconductor relay) is built into the master cylinder solenoid and drives the pump motor based on a signal from the skid control ECU.
DTC No.
DTC Detecting Condition
Trouble Areas
C1251/51
Open in motor system circuit (motor input circuit)
  1. Brake booster pump assembly
  2. Master cylinder solenoid (skid control ECU)

INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform zero point calibration (Click here).

HINT:
Remove the hydraulic brake booster before the inspection (Click here).


1. CHECK BRAKE PUMP MOTOR WIRE HARNESS CONNECTION (MT+ / MT-)
  1. Using a screwdriver, remove the 2 plugs from the hydraulic brake booster (Click here).

  1. Check the tightening torque of 2 screws which fasten the wire harness connecting the hydraulic brake booster and brake booster pump (Click here).

Torque:
2.9 N*m{ 30 kgf*cm , 26 in.*lbf }



NG
RETIGHTEN SCREWS
OK


2. CHECK RESISTANCE OF PUMP MOTOR WIRE HARNESS (MT+/MT-)

  1. F052356E02
    Using a screwdriver, remove the 2 screws and pull the wire harness from the hydraulic brake booster.

  1. Measure the resistance between the red wire (MT+) and black wire (MT-).

    Standard resistance:
    Below 2 Ω



NG
REPLACE BRAKE BOOSTER PUMP ASSEMBLY (Click here)
OK


3. RECONFIRM DTC
  1. Reassemble the hydraulic brake booster, then reinstall the hydraulic brake booster.

  1. Clear the DTC (Click here).

  1. Check if the same DTC is detected (Click here).

    Result:
    Result
    Proceed to
    DTC output
    A
    DTC not output
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C1251 Open in Pump Motor Circuit (from Aug 2012)C1252 Brake Booster Pump Motor on Time Abnormally Long (Nov 2010 – Jul 2012) →