2011-2016 FJ Cruiser · Service Manual BRAKE

TRC OFF Indicator Light does not Come ON

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

DESCRIPTION

Click here

WIRING DIAGRAM

Click here.

INSPECTION PROCEDURE

NOTICE:
  1. Before troubleshooting, check that the transfer indicator switch (L4 position) circuit and the A-TRC switch circuit are both off.
  2. When replacing the master cylinder solenoid, perform zero point calibration (Click here).


1. CHECK TRC OFF INDICATOR LIGHT
  1. Disconnect the skid control ECU connector.

  1. Turn the ignition switch to ON.

  1. Ground terminal VSCW of the skid control ECU.

  1. Check the TRC OFF indicator light.

    OK 
    VSCW - GND Condition
    Illumination Condition
    Connecting
    ON
    Disconnecting
    OFF



NG
Go to step 2
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)

2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER)

  1. C135294E06
    Disconnect the skid control ECU connector.

  1. Disconnect the combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-36 (VSCW) - E14-6 (VSCW)
    Always
    Below 1 Ω
    A4-36 (VSCW) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT COMBINATION METER ASSEMBLY
  1. Check the combination meter system (Click here).

    OK:
    Combination meter is normal.



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE MASTER CYLINDER SOLENOID (Click here)


← TRC OFF Indicator Light does not Come ON (Aug 2008 – Jul 2009)TRC OFF Indicator Light does not Come ON (Nov 2010 – Jul 2011) →