VSC OFF Indicator Light does not Come ON
Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Jul 2007 – Jul 2008 Aug 2008 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012
DESCRIPTION
Click here.WIRING DIAGRAM
Click here.INSPECTION PROCEDURE
- NOTICE:
- When replacing the master cylinder solenoid, perform zero point calibration (Click here).
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (VSC OFF INDICATOR LIGHT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the tester on.
Select the following menu items: Chassis / ABS/VSC/TRC/ Active TestSelect the "Turns VSC/TRC OFF indicator light" in the Active Test and operate the VSC OFF indicator light using the intelligent tester.
ACTIVE TEST: ABS/VSC/TRC Tester Display
Test Part
Control Range
Diagnostic Note
VSC/TRC OFF Indicator Light
VSC OFF indicator
VSC OFF indicator ON or OFF
Observe combination meter
Check that the VSC OFF indicator light turns on and off in the combination meter using the intelligent tester.
- OK:
- The VSC OFF indicator light turns ON and OFF in accordance with the intelligent tester operation.
|
|
||||
| OK | ||
| ||
| 2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - COMBINATION METER) |
Disconnect the skid control ECU connector.

Disconnect the combination meter connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Specified Condition
A4-35 (WT) - E14-5 (TROF)
Below 1 Ω
A4-35 (WT) - Body ground
10 kΩ or higher
|
|
||||
| OK | |
| 3. INSPECT COMBINATION METER ASSEMBLY |
Check the combination meter system (Click here).
- OK:
- Combination meter is normal.
|
|
||||
| OK | ||
| ||
